esphome:
  name: esp360remote

esp32:
  board: esp32doit-devkit-v1
  framework:
    type: arduino

# Enable logging
logger:

# Enable Home Assistant API
api:
  services:
    - service: send_ir_raw
      variables:
        command: int[]
      then:
        - remote_transmitter.transmit_raw:
            transmitter_id: IR_TX
            code: !lambda 'return command;'
    - service: send_rf_raw
      variables:
        protocol_number: int
        raw_data: string
      then:
        - remote_transmitter.transmit_rc_switch_raw:
            transmitter_id: RF_TX
            protocol: !lambda 'return  esphome::remote_base::RC_SWITCH_PROTOCOLS[protocol_number];'
            code: !lambda 'return raw_data;'

ota:
  password: ""

wifi:
  ssid: "nossid"
  password: "nopassword"

  #HotSpot quando non riesce a collegarsi al WiFi
  ap:
    ssid: "Esp360Remote"
    password: "Esp360Remote"

captive_portal:
    
#Definizione pin della porta i2c
i2c:
  sda: 21
  scl: 22
  scan: true
  id: bus_a

#Aggiunti degli offset sulle misure effettuate. 
#Sono necessarie per via del calore della pcb, del secondo strato della scheda e del case
#In questo modo si ottengono dei valori sufficientemente precisi per le automazioni
sensor:
  - platform: shtcx
    temperature:
      name: "Living Room Temperature"
      filters:
        - offset: -4
    humidity:
      name: "Living Room Humidity"
      filters:
        - offset: +19.1   
    address: 0x70
    update_interval: 120s
  - platform: bh1750
    name: "BH1750 Illuminance"
    address: 0x23
    update_interval: 1s

#Impostazione dei ricevitori IR e RF
remote_receiver:
  - id: RF_RX
    pin: 
      number: GPIO5
      inverted: True
    dump: 
      - rc_switch
    tolerance: 35%
    filter: 200us
    idle: 4ms
    buffer_size: 10kb
    on_rc_switch:
      - homeassistant.event:
          event: esphome.rf_code_received
          data:
            protocol: !lambda 'return x.protocol;'
            code: !lambda 'return x.code;' 
  - id: IR_RX
    pin: 
      number: GPIO19
      inverted: True
    dump: all


#Impostazione dei trasmettitori IR e RF
remote_transmitter:
  - id: RF_TX
    pin: GPIO18
    carrier_duty_percent: 100%
  - id: IR_TX
    pin: GPIO13
    carrier_duty_percent: 50%


web_server:
  port: 80

#Status LED 
switch:
  - platform: gpio
    pin: 12
    name: "Status Led"
    restore_mode: ALWAYS_ON
